SNOWJOE iON18SB-HYB, Operator'S Manual

11

Charging the Battery

1.  Pull the push lock button on the battery to pull the battery 

pack up and out of the equipment (Fig. 7).

2.  Check that the mains voltage is the same as that marked 

on the rating plate of the battery charger. Then, insert the 

charger's plug into the electrical wall outlet. When you 

plug in the charger, the top green light will illuminate and 

stay green (Fig. 8).

3.  Place the battery pack into the charger by sliding the pack 

as shown to lock it into position. When you insert the 

battery into the charger, the bottom red light will 

illuminate 

to indicate that the battery is charging (Fig. 9).

4. 

When the bottom light turns green, the battery is fully 

charged (Fig. 9).

NOTE: If the top light remains green while the bottom light 

alternately flashes red and green, this indicates a temperature 

abnormality (i.e. that the battery pack is either too hot or too 

cold). If there is only a red blinking light, this indicates that 

something is wrong with the battery. Contact Snow Joe

®

 + 

Sun Joe

®

 customer service center at 1-866-SNOW-JOE  

(1-866-766-9563) for assistance.

5.  A fully discharged pack with an internal temperature in the 

normal range will fully charge in 2.5 to 3 hours (between 

32ºF/0ºC and 113ºF/45ºC). Heavily cycled battery packs 

may take longer to charge completely.

6.  If the charging light indicator alternately blinks red and 

green or the light indicator does not come on at all, check 

that the battery pack is fully seated into the bay. Remove 

the pack and reinsert. If the problem persists, contact the 

Snow Joe

®

 + Sun Joe

®

 customer service center at  

1-866-SNOWJOE (1-866-766-9563) for assistance.

Fig. 7

Push lock

button

Fig. 8

green

Power on

Fig. 9

green

green

Fully charged

green

red

Charging

Green

Flashing red/green

Temperature abnormal

Flashing red only

Something is wrong