7
NOTE:
The screwdriver has been shipped in a low charge
condition and should be fully charged before use.
1. Plug the charger adapter into an appropriate AC power
outlet. Connect the AC adapter charger plug into the
charging socket of the screwdriver
(Fig.
2
).
NOTE:
The
charge level indicator LED light will illuminate red
when the charger is plugged in and is charging the screwdriver.
2.
The battery will take approximately 3 hours to charge.
Charging may take up to 5 hours due to the level of charge
left in the battery and the ambient temperature.
NOTE: When the batte
ry is fully charged, the charging process
stops and the charging indicator light will automatically turn
OFF.
Assembly
• Before inserting the bit, make sure the f reverse
selector switch is in the center “LOCK” position to prevent
accidental starts that may result in injury (Fig. 3).
• When removing the bit from the tool, avoid contact with
skin and use proper protection gloves when grasping the
bit. Bits may be hot after prolonged use.
Pivoting Head
The head of the tool can be pivoted for optimum versatility.
1. Press the pivot release button to rotate the tool head to
the inline position (Figs. 4 & 5).
2. Release the button.
m
WARNING!
Check to make sure tool handle is locked
after pressing pivot release button and changing screwdriver
positions.
Operation
Ins Removing Screwdriver Bits
1. Position the f reverse selector switch to the
center “LOCK” position (Fig. 3).
2. Select the driving bit best suited for the job and insert it
into the cavity in the bit collet (Figs. 6 & 7).
Fig. 2
Charger
plug
Charger
socket
Charging
indicator
light
Fig. 3
F reverse
selector switch
Center "LOCK"
position
Fig. 4
Pivot release button
Fig. 5
Inline Position
4
5
6 PH1 PH2 PH3 PZ1 PZ2 PZ3 H3 H4
Fig. 6
50 mm Phillips PH1
25 mm bits (11 pcs)
50 mm flat-head #4
