14
NOTE: To avoid any leaking, make sure to lock the latches
on both sides at the same time when assembling the tank.
Clean the Nozzle
During longtime use, the nozzle may become clogged. Follow
the instructions below to clean clogged nozzle.
1.
Turn off the unit and remove the battery.
2. Unscrew and remove the nozzle from the spray wand
(Fig. 15).
3. Push a narrow string through the cross holes to clear any
debris (Fig. 16). If necessary, rinse the cross holes and
nozzle with clean water.
4. Wipe the nozzle and cross holes with a clean dry cloth and
reinstall the nozzle.
Clean the Filters
Periodically clean the filters on the suction tube and inside the
trigger gun. Follow the instructions below:
1.
Make sure the tool is switched off and the battery is
removed.
2. Release the tank latches on both sides, and lift up the
motor housing from the tank (Fig. 14).
3.
Pull out the suction tube filter from the suction tube to
expose the suction tube filter (Fig. 17). Rinse the filter with
warm water to prevent any foreign matter from clogging
inside (Fig. 18).
4. Unscrew the trigger gun connection from the hose and
disconnect the trigger gun from the hose. Then remove the
trigger gun filter that is located inside the trigger gun
(Fig. 19).
5.
Rinse the trigger gun filter with warm water to prevent any
foreign matter from clogging inside (Fig. 20).
Fig. 15
Fig. 16
Cross hole
Fig. 17
Motor housing
Suction tube
Suction tube
filter
Fig. 18
Suction tube
filter
Fig. 19
Trigger gun filter
Trigger gun
connection
Trigger gun
Fig. 20
Trigger gun
filter
