SNOWJOE Sunjoe 24V-SSEG-LTE, Operator'S Manual

10

2.  Place the blade cover down and make sure it clicks into 

place with the tabs on the motor housing (Fig. 5).

3.  Make sure the latches on each side of the blade cover 

snap into place and that the blade is secured in the 

product before beginning operation (Figs. 6 – 7).

4.  To remove the blades, gently press the latches on both 

sides and lift the blades up (Fig. 6).

NOTE: If you have any questions, please call the Snow Joe

®

 + 

Sun Joe

®

 customer service department at 1-866-SNOWJOE 

(1-866-766-9563) for assistance.

Operation

IMPORTANT! The product is intended for light-duty trimming 

of shrubs for residential properties.

m

WARNING! 

The blades continue to move for a few 

seconds after the tool is switched OFF. Turn OFF the tool and 

wait until the blades come to a complete stop before adjusting 

or cleaning.

m

CAUTION!

Never touch the blade or blade rail while 

the tool is in operation and be aware of the sharp edges even 

when the hedge trimmer is not in use.

St Stopping

1.  Insert the battery fully in the battery compartment (Fig. 8).

Fig. 4

Blade cover tab

Fig. 5

Tabs

Slots

Fig. 6

Blade

Latch

Blade cover

Fig. 7

Fig. 8

Battery 

compartment

Battery