12
Side Discharge Chute As Fitting
Use the side discharge chute on your mower when the grass is
too tall to mulch or when side discharging is preferred.
The grass clippings produced by the side discharge chute are
noticeably larger than those produced by the mulching plug.
NOTE: When using the side discharge chute, do not assemble
the grass collection bag. Insert the mulching plug in the rear
discharge opening.
1. Lift up the side discharge door.
2. Align the grooves on the side discharge chute with the
pins on the underside of the door, and hook the grooves
on the pins (Fig. 10).
3. Release the side discharge door.
Mulching Plug As Fitting
Your mower is equipped with a mulching plug to allow the
blade to cut and recut the grass for finer clippings.
NOTE: When using the mulching plug, do not assemble the
grass collection bag or the side discharge chute.
NOTE: When the grass collection bag is not attached, the
mulching plug must be inserted in the rear discharge opening.
1. Lift up the ejector flap.
2. Insert the mulching plug fully into the rear discharge
opening and make sure it's seated securely (Fig. 11).
3. Release the ejector flap.
Operation
This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms or
forests. Do not use this lawn mower for any application other
than that for which it is intended.
Adjusting the Cutting Height
This cordless lawn mower is equipped with a 7-position height
adjustment lever to tailor grass cutting heights from 1.2 in. to
3.5 in. (30 mm to 90 mm). To change the cutting height of the
grass, follow the instructions below.
m
WARNING!
Before making these adjustments, remove
the batteries and the safety key from the lawn mower and wait
until the rotating blade has come to a complete standstill.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off the lawn mower and remove the batteries and
the safety key (Fig. 12).
2. Push the cutting height adjustment lever to the outside of
the original slot (Fig. 13).
Fig. 10
Side discharge door
Grooves
Pins
Side discharge
chute
Fig. 11
Mulching plug
Ejector flap
Rear
discharge
opening
Fig. 12
Battery packs
Safety key
