SNOWJOE SUNJOE iON16LM-HYB-RM, Operator'S Manual

19

iCHRG40

Federal Communications Commission (FCC)

m

WARNING!

 Any changes or modifications to this unit not expressly approved by the party responsible for compliance 

could void the user's authority to operate the equipment.
Class B device:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 

FCC Rules. 

These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

Troubleshooting

IMPORTANT!

 For protection, the motor is equipped with a thermal switch that cuts out when the motor is overloaded and 

switches on again automatically after a short cooling period.

Motor does not start

Motor performance 

drops

Unclean cuts

a)  Capacitor defective
b)  Battery pack empty
c)  Cable defective
d)  Switch/plug block defective
e)  Motor terminals or capacitor 

disconnected

f)  Mower standing in high grass
g)  Mower housing is clogged
h)  Safety key is not inserted
i)  Battery is not correctly inserted

a)  Contact an authorized service center
b)  Charge battery pack
c)  Check the cable
d)  Contact an authorized service center
e)  Contact an authorized service center
f)  Start motor on shorter grass or 

previously mowed area; change 

cutting height if necessary

g)  Clean housing so that the blade can 

run freely

h)  Insert safety key into one of the slots
i)  Remove the battery and reinsert

a)  Grass too tall or damp
b)  Mower housing is clogged
c)  Blades badly worn
d)  Battery performance decreasing

a)  Correct the cutting height
b)  Clean housing
c)  Replace blades
d)  Check the battery performance and 

charge the battery if necessary

a)  Blades worn
b)  Wrong cutting height

a)  Replace or resharpen the blade; contact 

an authorized service center

b)  Correct the cutting height

Fault

Possible Cause

Remedy