17
iCHRG40
Federal Communications Commission (FCC)
m
WARNING!
Any changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Class B device:
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Troubleshooting
IMPORTANT!
For protection, the motor is equipped with a thermal switch that cuts out when the motor is overloaded and
switches on again automatically after a short cooling period.
Motor does not start
Motor performance
drops
Unclean cuts
a) Capacitor defective
b) Battery pack empty
c) Cable defective
d) Switch/plug block defective
e) Motor terminals or capacitor
disconnected
f) Mower standing in high grass
g) Mower housing is clogged
h) Safety key is not inserted
i) Battery is not correctly inserted
a) Contact an authorized service center
b) Charge battery pack
c) Check the cable
d) Contact an authorized service center
e) Contact an authorized service center
f) Start motor on shorter grass or
previously mowed area; change
cutting height if necessary
g) Clean housing so that the blade can
run freely
h)
Insert safety key (Fig. 13)
i) Remove the battery and reinsert
a) Grass too tall or damp
b) Mower housing is clogged
c) Blades badly worn
d) Battery performance decreasing
a) Correct the cutting height
b) Clean housing
c) Replace blades
d) Check the battery performance and
charge the battery if necessary
a) Blades worn
b) Wrong cutting height
a) Replace or resharpen the blade; contact
an authorized service center
b) Correct the cutting height
Fault
Possible Cause
Remedy
