SNOWJOE SUNJOE MJ24C-14-XR-RM, Operator'S Manual

14

•  Maintain a solid footing and wear sturdy, non-slip footwear 

and long trousers. Always mow across an incline (not up 

and down). 

•  For safety reasons, the lawn mower may not be used to 

mow inclines with gradients exceeding 15 degrees.

•  Use special caution when backing up and pulling the lawn 

mower towards you as such maneuvering of the machine 

poses a tripping hazard.

Maint Care

m

WARNING!

 Before cleaning, repairing or inspecting 

the mower, disconnect the power supply by plugging out the 

safety key and verify that all moving parts have come to a 

complete stop.

General

•  Always keep the mower clean and free of grass, dirt or 

other debris.

•  Keep the handles dry, clean and free of oil and grease. 
•  After each cutting session, remove accumulated grass 

clippings and debris using either a dry cloth or handbrush. 

You may also clean the equipment with a damp cloth and 

some soft, non-abrasive soap. Do not use cleaning agents 

or harsh solvents as they may damage the equipment's 

plastic components. Make sure that no water penetrates 

the equipment's interior as intake of water can destroy the 

switch/plug mechanism and the electric motor.

•  Do not clean the lawn mower with running water, 

particularly with high-pressure water. 

•  Check all nuts, bolts and screws for proper tightness 

before each use.

•  Frequently inspect the grass collection bag assembly for 

signs of wear and replace immediately with a genuine part 

if damage is found. 

•  Replace excessively worn or damaged parts immediately.
•  To maximize your mower's longevity, all screwed parts, 

including the wheels and axles, should be cleaned and 

lubricated. There are no parts inside the equipment which 

require additional maintenance or lubrication. 

Blade Maintenance

IMPORTANT:

 The mower blade is sharp and can cause severe 

personal injury if handled incorrectly. Wrap the blade or wear 

protective gloves, and use extra caution when handling.
The steel blade is designed to provide a fine cut in long or 

tough grass. Deterioration in the quality of cut indicates blade 

wear or damage. Follow these steps to determine if the blade 

needs to be resharpened or replaced: 

1.  Disconnect the power supply to the mower by removing 

the safety key.

2.

  Turn the mower on its side to expose the underside of the 

blade housing.

3.  Check the blade.

a.  If the blade is blunt or has minor wear, then resharpen. 
b.  If the blade shows signs of major wear or damage  

(i.e. gouged, bent), replace. 

m

WARNING!

 An excessively vibrating mower indicates 

that the blade is not properly balanced or has become 

deformed from striking an object. In this case, the blade must 

be repaired or replaced. Please follow the proper maintenance 

procedures for blade care.

Blade Replacement

IMPORTANT: 

Only use original replacement parts specified 

for this mower. The use of parts that do not meet the original 

equipment specifications may lead to improper performance of 

the lawn mower, may compromise operator safety.

1.  Disconnect the safety key to the mower.
2.

  Turn the mower on its side to expose the underside of the 

blade housing.

3.  Use a cloth to grip the blade or wear heavy-duty gloves.
4.  Using the spanner provided, remove the bolt and 

the washer securing the blade by turning the bolt 

counterclockwise, then carefully remove the blade  

(Fig. 16).

5.  Fit the new blade, the washer and the bolt back on 

following the same steps in reverse order (Fig. 17).

Fig. 16

Blade

Spanner