5
m
WARNING!
Your fire pit was designed and approved
for OUTDOOR use only. DO NOT use it inside a building or any
other enclosed area.
• Ensure that the area is well ventilated and free of
obstructions.
• Follow the spacing tolerances shown in (Fig. 4)
m
CAUTION!
When certain materials or items are left,
above, beside or under this fire pit while in use, they will be
subject to radiant heat and could be seriously damaged.
Connecting Your Gas Cylinder
1. Open the door panel, attach regulator to the gas cylinder
and turn clockwise to tighten (Fig. 5).
NOTE: Only use the regulator supplied with this fire
pit. Only replace them with those specified by the
manufacturer.
2. Place the gas cylinder into the clamp in the base of the
fire pit with the regulator facing OUTWARDS. Turn the
tightening screw clockwise to secure it in place (Fig. 6).
Leakage Check
1. Mix a solution of 1 part liquid soap and 3 parts water.
2. Turn the propane cylinder valve until fully open.
3. Spoon (or squirt) several drops of the solution on to the
gas hose, regulator and cylinder valve (Fig. 7).
4. Inspect the connections and look for bubbles. If no
bubbles appear, the connection is safe.
5. If bubbles appear there is a leak. Turn off the cylinder
valve, then loosen and retighten the regulator.
6. Check for leakage again.
Fig. 4
35"
35"
60"
Fig. 5
Gas cylinder
Regulator
Fig. 6
Regulator
facing out
Clamp tightening
screw
Fig. 7
Gas hose
Cylinder valve
Regulator
