SNOWJOE SUNJOE SWJ806E-RM, Operator'S Manual

12

3. 

Extend the pole to the desired length (Fig. 21). 

NOTE: 

Push poles toward each other to shorten the pole 

or pull them away from each other to lengthen the pole. 

Only extend the pole to the minimum length required to 

reach the limb to be cut.

4. 

Lock the pole in position by closing the cam-lock (Fig. 22), 

and ensure that the pole is secure. If the pole telescopes 

when the cam-lock is closed, the nut may need tightening.

m

WARNING! 

Failure to lock the telescopic pole cam-lock 

as directed could result in personal injury.

Tightening the Bolt (Optional)

The retaining bolt may need tightening to secure the 

telescoping pole in place. 
To tighten the bolt, unclip the cam-lock. Using the hex key 

wrench, tighten the cam-lock nut, then close the cam-lock. 

Ensure that the pole is secure. The wrench may be required 

to loosen the cam-lock nut if you need to adjust the pole to a 

different height (Fig. 23).

Cutting Tips for Pole Chain 

Saw

Proper Cutting Stance

• 

Balance your weight with both feet on solid ground.

• 

Your body should always be to the left of the chain line.

• 

The most typical cutting application is to position the 

unit at an angle of 60° or less depending on the specific 

situation (Fig. 24). As the angle of the pole chain saw shaft 

to the 

ground increases, the difficulty of making the first 

cut (from the underside of limb) increases.

Fig. 21

Telescoping pole

Fig. 22

Cam-lock

Fig. 23

Hex key wrench

Cam-lock nut

R

Fig. 24

60º MAXIMUM