Mini Dart
Assembly instruction………………………………………………….
SoaringModels
3
Materials and tools for the installation of the model:
Picture 1.2. Materials and tools
1)
Liquid superglue (Akfix
702);
2)
Superglue activator;
3)
Epoxy;
4)
Masking tape;
5)
Sandpaper №240-320;
6)
Drills
Ø
2,
Ø
5;
7)
Needle file (round and
flat);
8)
Pliers;
9)
Screwdriver;
10)
Ruler;
11)
Stationery knife;
12)
Pencil.
Necessary radio equipment for the assembly:
1)
Accumulator 250-300 mAh, recommended sizes 17*30 mm;
2)
Servo-drivers Power HD 1440 or Dymond D-47 (4 pieces);
3)
6-channel receiver.
2.
Assembly
2.1.
Insert of pylons
Cut the grooves for the pylons with a knife as it is shown in the pictures 2.1-2.4
In the rudder in the right in the middle
In the elevating rudder at the distance of 103 mm from the left edge
In ailerons at the distance of 40 mm from the centre of the wing
Paste in the pylons using the epoxy.
Avoid contact of the superglue with the foam plastic of the wing and the plumage
cores!
Picture 2.1. Pasting in the pylon of the rudder
