3
DB22 STEAM IRON
INSTRUCTIONS
In particular:
- Never touch the appliance with damp or wet hands or feet. Never immerse the
iron in liquids.
-
The appliance must not be used in damp rooms or rooms used as bathrooms.
- The appliance should not be used by children.
-
When the appliance is switched on it must not be left unattended as it represents
a source of danger in this state.
-
Never pull the plug out of the socket by the cable.
-
Always disconnect before cleaning the appliance or before any maintenance
measures.
- In the event of any damage and/or malfunctioning, switch the appliance off and
do not try to repair it yourself. If any repairs should be necessary, please contact
the after sales service. Insist that only original parts are used. The safety of the
appliance cannot be guaranteed if this directive is not followed .
-
The lead must not be changed by the user. Always contact the after sales service
if the lead is damaged or if it is necessary to change it.
-
Never hold the appliance under the tap when filling with water.
-
Make sure that the lead does not come into contact with the hot parts of the
iron.
-
The iron gets very hot when in use. Consequently, there is a danger of burns.
Always grasp the iron by the handle and avoid any contact with the metal parts
or steam.
-
Never point the burst of steam towards anyone.
-
Do not use the iron on very moist fabrics.
-
Do not stand the iron on the sole plate when it is hot. Wait until it has cooled
down.
-
Do not apply stain removers or similar products to fabrics before ironing.
-
Disconnect from the mains when you are not using the iron. Do not leave the iron
plugged in when it is not absolutely necessary.
-
This appliance has a safety mechanism. The iron is switched off when this is
triggered. Contact the after sales service to restore the iron to the original
condition.
OPERATING INSTRUCTIONS
Ironing without steam
1. Place the iron on a steady, heat resistant surface.
2. Set the temperature dial (4) to the MIN position (Fig. B).
3. Turn the steam setting switch (8) to the 0 position (Fig. C).
4. Stand the iron vertically on its rest base (11).
5. Plug the iron in and set the ironing temperature on the
temperature dial. The pilot light (9) lights up.
6. As soon as this light goes out the iron is at the set tempe-
rature. This pilot light switches on and off at regular inter-
vals while you are ironing indicating the thermostat cycles.
When you switch to a lower temperature make sure that
