20
Vers. 005 Feb 2020
Figure 6 shows a horizontal chain conveyor
The covers for the extension sections and the outlet sections are mounted.
Where the inlets are to be placed, a hole is cut in the cover to fit with the transition in
question (see figure 6).
Figure 6
If the chain conveyor must be placed in an angle of 10°-30°, a chain conveyor with
intermediate plate and extended flights is used. The inlet hopper is placed minimum 300 mm
from the tail section. A hole must be cut in the intermediate plate so that the conveying
material (grain) will come down through the inlet hopper, lands on the intermediate plate and
is being conveyed by the return flights down through the hole to the lower chamber (see
figure 7)
Figure 7