M820L Hybrid Codec PCI Express Card User's Manual
Rev. 1.3a
Nov. 22, 2019
7
Copyright 2018-2019 Socionext Inc.
6.
M820L Hardware Setup
This chapter describes the M820L hardware setup method.
6.1.
Confirmation of PCI Express I/O Bracket
Firstly, confirm the PCI Express I/O bracket to be used of the PC/server chassis.
If the standard bracket is used, it is necessary to replace the bracket with the standard bracket because
the low profile bracket is attached to M820L before shipping.
Note:
The screws attached as the deliverables cannot be reused.
6.2.
Installing M820L in PC/Server Chassis
After the replacement of the bracket as necessary, install M820L in the PC/server chassis which has the
PCI Express card slot as shown below.
Figure 6-1: M820L installed in server chassis
Turn on the PC/server chassis after confirming M820L is correctly installed in its PCI Express slot. The
M820L power supply is provided from PCI Express card edge power (+12 V).
In case of the M820L removal from PC/server chassis, remove the card after confirming the PC/server
chassis in which the card has been installed is turned off. After removing the card, put the card into the
ESD-protective case, bag, sheet, etc.
Caution:
Depending on the M820L operating conditions, the surface of the devices on M820L may become
extremely hot and possibly cause burns. Pay attention not to touch the surface of these devices when
removing M820L from the PC/server chassis after the M820L operation is completed.
M820L
