4
7
Set Lengths for Code 93
Parameter # L1 = 0x1A, L2 = 0x1B
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 93 may be set for any length,
one or two discrete lengths, or lengths within a specific range. To set lengths via serial
commands, see
Setting Code Lengths Via Serial Commands
on page 7.
One Discrete Length
- Select this option to decode only those codes containing a selected
length. For example, select
Code 93 One Discrete Length
, then scan
1
,
4
, to limit the
decoding to only Code 93 symbols containing 14 characters. Numeric bar codes begin on
page
82
. To change the selection or cancel an incorrect entry, scan the
Cancel
bar code
on
page
84
.
Code 93 - One Discrete Length
Two Discrete Lengths
- Select this option to decode only those codes containing two
selected lengths. For example, select
Code 93 Two Discrete Lengths
, then scan
0
,
2
,
1
,
4
, to limit the decoding to only Code 93 symbols containing 2 or 14 characters.
Numeric bar codes begin on
page
82
. To change the selection or cancel an incorrect
entry, scan the
Cancel
bar code on
page
84
.
Code 93 - Two Discrete Lengths
