4.4 Types of tools, usage and lifetime
Tools differentiate on the basis of the different shapes of their terminal parts. There are various
types of tools capable of meeting the requirements of every kind of work.
Flat terminal tool (ref. A)
It is suitable for stoke crushing.
Normally used on small and medium hammers.
Pyramidal terminal tool (ref. C)
The use is similar to the one described up-above. To be mounted on small hammers.
Cone-shaped terminal tool (ref. D)
Suitable for the demolition of walls and non-reinforced concrete structures, for stones and
quite soft materials. To be mounted on the whole range of hammers.
Small spade terminal tool (ref. E) or asphalt-cutter tool (ref. F)
Suitable for tracing the lines marking the limits of the diggings. To be mounted only on small
and medium hammers.
Chisel terminal tool (ref. B)
Used for mining in general. It is
essential in demolitions where a high
cutting capacity is required: for
example walls, floors and reinforced
concrete buildings, fixed section,
diggings and excavations in stone.
Not suitable for stone crushing.
It covers 80% of the applications on
small and big hammers.
A
B
C
D
E
F
USE OF THE HAMMER
18
Page
of 48
4
Nederland B.V.
Summary of Contents for MDO 1600 TS
Page 34: ...44 39 41 43 45 36 35 38 40 42 46 37 STROKE CHANGER 34 Page of 48 10 Nederland B V ...
Page 40: ...101 96 98 100 99 97 DISTRIBUTOR GROUP 40 Page of 48 13 Nederland B V ...
Page 42: ...107 104 106 101 105 109 108 103 102 ACCUMULATOR GROUP 42 Page of 48 14 Nederland B V ...
Page 46: ...129 132 125 134 127 128 126 133 130 133 131 GREASING SYSTEM 46 Page of 48 16 Nederland B V ...