en
15
Before Initial Use
PLEASE NOTE!
■
WARNING – Danger of Suffocation!
Keep children and animals away from
the packaging material.
1. Remove the device and accessories
from the packaging. Check the items
supplied for any transport damage. If
you
fi
nd any damage to them, do not
use them (!), but contact our customer
service department.
2. Remove any possible transport re-
straints.
3. Insert the CO
2
cylinder into the device
(see “Inserting the CO
2
Cylinder”).
4. Thoroughly clean the water bottle (see
"Cleaning and Storage").
Inserting the CO
2
Cylinder
PLEASE NOTE!
■
CAUTION
– Cold Burns!
The CO
2
cylinder may be very cold after use.
After the last bubbling, wait for around
10 minutes before replacing it.
■
The water bottle must not be inserted
in the device when the CO
2
cylinder is
inserted or removed.
■
Do not use any tools!
(See back fold-out page for illustrations)
1. Place the device on a
fl
at and stable
surface.
2. Peel the protective
fi
lm off the CO
2
cylinder head and unscrew the protec-
tive cap. Keep the protective cap and
screw it back onto the emptied cylinder
later on.
3. Screw the adapter hand-tight onto the
CO
2
cylinder head.
4. On the back of the device, press down
the release button with one hand and
use your other hand to
fl
ip the back
cover away from the device, then re-
move it.
5. Before initial use, remove the trans-
port restraint from the cylinder holder:
Press the ring-shaped lever on the cyl-
inder holder up as far as it will go; the
transport restraint will drop out.
6. First place the CO
2
cylinder into the
opening in the bottom of the device,
then tilt the device forwards slightly.
7. Press the lever on the cylinder holder
upwards, press the CO
2
cylinder with
adapter as far as it will go into the cyl-
inder holder, twist it slightly if neces-
sary until it engages.
8. Let go of the lever again. Check that
the CO
2
cylinder
fi
ts securely. It must
hang in the device.
9. Insert the back cover with the wider
side
fi
rst into the bottom of the device
(plug its locking lug into the opening
in the bottom of the device) and then
fl
ip it shut carefully. Make sure that the
back cover is not twisted.
We recommend that you get at
least one spare CO
2
cylinder so
that you can produce sparkling wa-
ter at any time. Further information
about this can be found at
www.sodatrend.de.
