86
Selection options for displaying the total
Deleting the totalising memory
The following functions can be assigned to the Sum function key in the setting mode:
>
Display, print and delete totals
After pressing the Total function key, the totals are displayed for 3 seconds, and the contents of the
memory are printed out and deleted simultaneously. You can then start a new totalising procedure.
>
Display totals only
After pressing the function key Total, the user can decide whether the total memory should be deleted
or not.
Press the F2 key to clear the total memory.
If you want to continue totalising without deleting the memory, press the F6 Back key.
Relief factor for totalising
(Cannot be activated during picking)
In the setting mode, you can specify that the scale must be unloaded by a certain number of digits between
the placement of the individual items.
If the weight is not discharged, the weight value is not stored in the totalising memory and the error message
"Error 55 Place weight on scale" appears. In this way, you can prevent, for example, double storage of an
item.
Auto Totalise
The Auto Totalise function can be activated in the setting mode.
In this case, you only need to confirm the first position by pressing the Plus key. All other positions are
automatically added after weight has been reached and stability is stored in the totalis
ing memory.
As long as auto totalising is active, the Plus key is dimmed.
If auto totalling is interrupted due to cancellation, error message or change of measuring point,
then auto totalling must be restarted with the Plus key.
Info: Auto totalising can be defined as a print-triggering condition in the same way as manual totalising.
(see chapter 8 Printing in the manual).
Assigning and deleting the sequential number
Each entry (plus, manual, cancellation) in the total memory increases a four-digit sequential number.
The sequential number is not reset in the factory setting.
Optionally, the consecutive number can be reset in the setting mode:
>
not active (no reset = factory setting)
>
Delete sum for key
>
when switching off
>
Function key "Delete current number".
Summary of Contents for 3025
Page 1: ...www soehnle professional com Operation Manual Terminal 3025 ...
Page 114: ...114 ...
Page 115: ...115 ...