88
Display individual items
Within a total, you can call up the individual items from the total memory,
by pressing the key and the F5 Plus key one after the other. The item list starts with the most recent
entry.
Use the arrow keys F3 (older entries) and F4 (newer entries) to cycle through the list.
The last 50 entries are available.
Press the F5 Back key to exit the display of the individual items and return to the previous display.
Totalising outside tolerance
You can prevent the totalling of quantities that lie outside a specified tolerance range. If the quantity is
outside the tolerance range, the error message "Out of tolerance" appears after you press the Plus key.
To do this, you must switch it off in the setting mode under "Totalising outside tolerance". You define the
target quantity and the permitted tolerance in the piece check mode.
Further information can be found under Check piece
Totalising of different counted parts
You can prevent the totalising of different parts by selecting "Clear total" in the Setup mode to allow a new
reference weight to be determined only after the totalising memory has been cleared.
6.7.7 Reference statistics
Determination of the weight tolerance of counted parts.
The weighing bridge with the finest resolution is used.
The piece weight must be greater than the smallest digit increment of the connected weighbridge.
Unload the scale. Press the F3 Ref Stat key.
The scale shows zero and requests "Place 1st sample on scale".
Place the sample on the scale, the scale takes over, goes to weight value zero and requests the second
sample.
The previous sample remains on the scale.
Repeat the procedure until the desired number of samples is reached.
Press the F6 Enter key to evaluate and display the statistics.
Summary of Contents for 3025
Page 1: ...www soehnle professional com Operation Manual Terminal 3025 ...
Page 114: ...114 ...
Page 115: ...115 ...
