15
EN
8. Weighing (Dia. 7)
Place scale on a smooth and level surface.
1. Switch on using the key
2. Wait until "0" is displayed. If the display does not show 0 g,
push the TARE key.
3. The weighing process can now start. Place goods to be weighed
on the scale and read the value. If a load is placed on the scale,
it switches off automatically after 8 minutes without any weigh-
ing activity (or after approx. 4 minutes if no load is on the scale).
The scale can also be switched off manually by pushing the
key for 2 seconds.
8.1 Tare and add-weight (Dia. 7)
1. After a container has been placed on the scale, it can be tared
using the TARE key. If goods to be weighed are then placed on
the scale, the display shows only that weight.
2. If several ingredients are to be weighed in one single container,
the TARE key must be pushed between each individual ingre-
dient so that “0” is displayed each time and the next ingredient
can be added.
3. If the TARE key is pushed once again after the last ingredient
and if the container is then removed from the scale, the total
weight (to include container) is displayed with a negative algeb-
raic sign.
4. Please note that the remaining, usable, maximum load capacity
is reduced by the tared weight values.
9. Wall installation (Dia. 8)
The scale can be placed on a surface using the folding base feet
or it can be attached on the wall. You will need appropriate tools
and installation material.
The outdoor sensor should also be attached to a protected out-
side wall with a screw.
66223_Page-Meteo-Center_9277-A_Content_28-07-2014.indd 15
05.08.2014 16:23:33
