Figure3-4 Moving the Sofar 30~40KTL (2)
Step 2
Lift the Sofar 30~40KTL from the packing case and move it to the installation position.
End
Step 1
To determine the position for drilling holes, level hole positions, and then mark the
hole position by using a marker, use the hammer dril to dril hole on the wall. Keeping the
hammer perpendicular to the wall, do not shake when drilling, so as not to damage the walls.
If the aperture errors, need to reposition.
Many sofar 30~40KTL installation
300mm
100mm
1000mm
200mm
This topic describes how to move the Sofar 30~40KTL to the installation position
horizontally
Step 1
Opening the packing, insert hands into the slots on both sides of the Sofar 30~40KTL
and hold the handles, as shown in Figure 3-3 and Figure 3-4. Two persons are required to
move the Sofar 30~40KTL.
Figure 3-3 Moving the Sofar 30~40KTL (1)
3.5 Moving the Sofar 30~40KTL
Procedure
Attention
To prevent device damag and personal injury, keep balance when moving the
sofar 30~40KTL because the Sofar 30~40KTL is heavy.
Do not put the Sofar 30~40KTL with its wiring terminals contacting the floor
because the power ports and signal ports are not designed to support the weight
of the Sofar 30~40KTL. Place the Sofar 30~40KTL horizontally.
When placing the Sofar 30~40KTL on the floor, put foam or paper under the
Sofar 30~40KTL to protect its shell.
3.6 Installing the Sofar 30~40KTL
Step 2
The expansion screw is vertically inserted into the hole, pay attention to expanding
screw insertion depth (not too shallow).
Step 3
Putting the rear panel on the wall, the rear panel is fixed by the nuts.
Step 1
Step 2
Step 3
All rights reserved
Shenzhen SOFARSOLAR Co ., Ltd.
C
21
All rights reserved
Shenzhen SOFARSOLAR Co ., Ltd.
C
22
User manual
User manual
Installation
Installation
Sofar 30K~40KTL
Sofar 30K~40KTL
Document Version 1.0(2015.08.06)
Document Version 1.0(2015.08.06)
Компания
«
Реалсолар
»,
Санкт
-
Петербург
,
Октябрьская
наб
.,
д
. 104,
к
. 1,
лит
.
П
www.realsolar.ru +7911-921-52-96
