10
SPA ASSEMBLY:
1.
Unfold the spa to lay flat and make sure the spa is right side up.
2.
Plug in the Main Power Unit to a grounded outlet.
3.
Connect the inflation hose to the center hose connection on the Main Power Unit.
WARNING
–
Make sure the inflation hose is screwed in tightly onto the
center hose connection, failure to screw in tightly may result in serious injury.
4.
Press the Massage Air Blower button to begin inflation.
NOTE – The Main Power Unit will make a rattling noise while the pump is
running with no water. This is not a defect. Do not run the Main Power Unit
without water for more than 15 minutes.
5.
Inflate the spa according to the sequence numbers printed on the spa, starting with
the number “1”.
6.
Inflate all chambers until they feel firm and turn Massage Air Blower off.
7.
Make sure all valves are closed completely.
8.
Detach inflation hose from the Main Power Unit.
9.
Line up the hose connections on the back of the pump with the fittings on the side
of the spa.