12
FILLING THE SPA:
1. Locate the floor drain valve and make sure that it is closed and the cap is installed.
Drain valve location Turn clockwise to close drain valve Hold base and tighten drain valve cap
Tighten pump / filter cover Tighten air purge valve
IMPORTANT – Make sure the Main Power Unit is not plugged in before filling
water into the spa.
2. Using the garden hose, fill the spa to the bottom of the fill line. Be careful not to
over fill the spa, or the spa may overflow during use. Each adult will raise the water
level in the spa approximately 2 inches, and the blower action will raise the water
level an additional 3 to 4 inches.
4.
IMPORTANT - Make sure that the filter pump inlet and outlet, located on
the inside wall of the spa, are opened by turning the valves counter-clockwise
(the nozzle does not come off, it stays loose when it is in the ‘OPEN’ mode)
and on some models, remove the outlet valve cover as well . Failure to do so
may affect the filtering and heating performance of the spa.
Turn ALL nozzles counter-clockwise On some models, remove the outlet valve cover