13
4. Bleed the air from the filter tank by turning the small knob on the top of the filter
tank counter-clockwise. Allow the filter tank to bleed air for approximately one
minute, or until water drips from the fitting. Turn the fitting clockwise to close the
bleed valve.
IMPORTANT – Make sure the Main Power Unit is not plugged in while
bleeding air.
5. Once bleeding is complete, plug the Main Power Unit into the electrical outlet.
Press the “Filter On” button located on the Main Power Unit control panel. The
pump will turn on and begin pumping water. Water should flow from the pump
outlet, located on the middle inside wall of the spa. If water is not flowing into and
out from the pump inlet and outlet, repeat the air bleeding instructions provided in
step 4, and make sure the inlet and outlet valves are open.
WARNING – When plugging into the outlet, make sure the outlet is properly
grounded.
6.
NOTE – If the air is not properly bled from the filter tank, the water pump
will be air bound and no water will flow. This will prevent the spa from heating,
and the water will not be filtered. Make sure that water is flowing into and out
from the inlet and outlet before continuing.
7. Select the desired heat level by pressing the “Heat On/Level” button, and place the
zippered cover over the spa and seal until the water reaches the desired temperature.
WARNING – Always supervise children around bodies of water. The spa cover
is not a safety cover. The spa cover is not a substitute for adult supervision.
WARNING – Always check to make sure there are no people or animals inside
the spa before putting on the spa cover, failure to do so may cause drowning and
or suffocation, and result in injury or death.
8.
WARNING – Always leave the cover locked and in place when the spa is not
in use. The cover is not a replacement for adult supervision. Always supervise
