SoftBank 104SH User Manual Download

Page: 114 / 122

112

Battery Cautions

Use specified Battery or Charger only.
Non-specified equipment use may cause malfunctions, electric
shock or fire due to battery leakage, overheating or bursting.
Do not dispose of an exhausted Battery with ordinary refuse;
always tape over battery terminals before disposal. Take
Battery to a SoftBank Shop, or follow the local disposal
regulations.
Charge Battery in ambient temperature 5

C - 35

C; Battery

may leak/overheat and performance may deteriorate outside
this range.

European RF Exposure Information

Your mobile device is a radio transmitter and receiver. It is
designed not to exceed the limits for exposure to radio waves
recommended by international guidelines. These guidelines
were developed by the independent scientific organization
ICNIRP and include safety margins designed to assure the
protection of all persons, regardless of age and health.
The guidelines use a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit for mobile
devices is 2 W/kg and the highest SAR value for this device
when tested at the ear was 0.521 W/kg*. As mobile devices
offer a range of functions, they can be used in other
positions, such as on the body as described in this user
guide**. In this case, the highest tested SAR value is 0.421
W/kg. As SAR is measured utilizing the device's highest
transmitting power the actual SAR of this device while
operating is typically below that indicated above. This is
due to automatic changes to the power level of the device
to ensure it only uses the minimum level required to reach
the Network. The World Health Organization has stated that
present scientific information does not indicate the need for
any special precautions for the use of mobile devices. They
note that if you want to reduce your exposure then you can
do so by limiting the length of calls or using a handsfree
device to keep the mobile phone away from the head and body.
*The tests are carried out in accordance with international
guidelines for testing.
**Please see "

Electromagnetic Safety

" for important notes

regarding body-worn operation.

Headphone Signal Level

The maximum output voltage for the music player function,
measured in accordance with EN 50332-2, is 26.0 mV.

FCC Notice

This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.

FCC Information to User

This equipment has been tested and found to comply with
the limits of a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation; if this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician
for help.