1-
5
Charging Battery
Battery must be inserted in handset to
charge it.
.
Use specified AC Charger ZTDAA1
(optional accessory) only. In this guide,
ZTDAA1 is referred to as "AC Charger."
.
AC Charger is not water or dust proof. Do
not charge Battery while handset is wet.
.
Handset/AC Charger may become warm
while charging.
1
Open Port Cover as shown
.
Pull at notch to open.
2
Insert Charger connector
.
With arrows facing up, insert Charger
connector until it clicks.
3
Extend blades and plug AC
Charger into AC outlet
.
Notification Lamp illuminates red
while charging.
.
Notification Lamp goes out when
Battery is full.
4
Unplug AC Charger
5
Remove Charger connector
from handset
.
Squeeze release tabs and pull
straight out.
6
Close Port Cover
.
Hold Port Cover and retract hinge
(
1
), then push edge to close (
2
).
7
Retract blades
Charging Battery (AC Charger)
Important AC Charger Usage Note
.
Retract blades after charging. Do not
pull, bend or twist cord.
AC 100
V
O
u
tlet
External De
v
ice
Port
AC Charger
N
otification Lamp
Charger Connector
Port Co
v
er
Arro
w
s
Up
Release
Ta
b
s
Blades
N
otch
Port Cover Cautions
.
Close Port Cover firmly after External
Device Port use. Debris trapped between
Port Cover and base may expose
handset to liquid/dust.
.
Do not try to close Port Cover with hinge
extended; may deform Port Cover and
affect water/dust resistance.
When Notification Lamp is Flashing
.
Battery is unchargeable; may be defective
or simply at the end of its life; replace it.
1
2
