SoftBank 945sh, Manual

42

43

General Notes

Electromagnetic Waves

For body-worn operation, this phone has been 

tested and meets RF exposure guidelines when 

used with accessories containing no metal, that 

position handset a minimum of 15 mm from 

the body. Use of other accessories may not 

ensure compliance with RF exposure guidelines.

CE Declaration of Conformity

In some countries/regions, such as France, there are 
restrictions on the use of Wi-Fi. If you intend to use Wi-Fi on 
the handset abroad, check the local laws and regulations 
beforehand.

Hereby, Sharp Telecommunications of Europe Ltd, declares
that 945SH is in compliance with the essential requirements 
and other relevant provisions of Directive 1999/5/EC.
A copy of the original declaration of conformity for each 
model can be found at the following Internet address:
http://www.sharp.co.jp/k-tai/

Battery - CAUTION

■

Use specified battery or Charger 

only.

Non-specified equipment use may cause 

malfunctions, electric shock or fire due to 

battery leakage, overheating or bursting.
Do not dispose of an exhausted battery with 

ordinary refuse; always tape over battery 

terminals before disposal. Take battery to a 

SoftBank Shop, or follow the local disposal 

regulations.

Charge battery in ambient temperatures 

between 5

℃

 and 35

℃

; outside this range, 

battery may leak/overheat and performance 

may deteriorate.

Mobile Light

■

Do not use Mobile Light near people's faces.

Eyesight may be temporarily affected leading to 

accidents.

CAUTION:

CLASS 1

LED Product

EN60825-1:1994  A1:2002 & A2:2001

Use of controls, adjustments or 

performance of procedure other 

than those specified herein may 

result in hazardous radiation 

exposure. As the emission level from Mobile Light 

LED used in this product is harmful to the eyes, do 

not attempt to disassemble the cabinet. Servicing 

is limited to qualified servicing station only.

Mobile Light

CAUTION-CLASS 2

LED RADIATION WHEN

OPEN DO NOT STARE

INTO THE BEAM

■

Mobile Light LED Properties

a) Emission Duration: Continuous

b) Wavelength

  White: 400 - 700 nm

c) Maximum Emission Output

  White: 1.1 mW (4.3 mW inside handset)

European RF Exposure Information

■

Your mobile device is a radio transmitter and 

receiver. It is designed not to exceed the limits 

for exposure to radio waves recommended by 

international guidelines. These guidelines were  

developed by the independent scientific 

organization ICNIRP and include safety margins 

designed to assure the protection of all persons, 

regardless of age and health.

The guidelines use a unit of measurement 

known as the Specific Absorption Rate, or SAR. 

The SAR limit for mobile devices is 2 W/k

g

.

As mobile devices offer a range of functions, 

they can be used in other positions, such as on 

the body as described in this user guide*.

Highest SAR value:

Model

At the Ear**

On the Body

945SH

0.828 W/k

g

0.751 W/k

g

As SAR is measured utilizing the device's highest 

transmitting power the actual SAR of this device 

while operating is typically below that indicated 

above. This is due to automatic changes to the 

power level of the device to ensure it only uses  

the minimum level required to reach the Network. 

The World Health Organization has stated that 

present scientific information does not indicate 

the need for any special precautions for the use 

of mobile devices. They note that if you want to 

reduce your exposure then you can do so by 

limiting the length of calls or using a handsfree  

device to keep the mobile phone away from the 

head and body. 
*Please see Electromagnetic Waves on 

P.42 

for 

important notes regarding body-worn operation.

**Measured in accordance with international 

guidelines for testing.

Headphone Signal Level

■

The maximum output voltage for the music 

player function, measured in accordance with EN 

50332-2, is 29.0 mV.

FCC Notice

This device complies with part 15 of the FCC 

.

Rules. Operation is subject to the following two 

conditions: 

(1) This device may not cause harmful 

interference, and (2) this device must accept  

any interference received, including 

interference that may cause undesired 

operation.

Changes or modifications not expressly 

.

approved by the manufacturer responsible for 

compliance could void the user's authority to 

operate the equipment.

FCC Information to User

■

This equipment has been tested and found to 

comply with the limits of a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These 

limits are designed to provide reasonable 

protection against harmful interference in a 

residential installation. This equipment generates, 

uses and can radiate radio frequency energy 

and, if not installed and used in accordance with 

the instructions, may cause harmful interference 

to radio communications.

However, there is no guarantee that interference 

will not occur in a particular installation; if this 

equipment does cause harmful interference 

to radio or television reception, which can be 

determined by turning the equipment off and 

on, the user is encouraged to try to correct the 

interference by one or more of the following 

measures: