SoftBank P00000401A01, Quick Manual

13

Right side

Left side

Attach the right side of

the Brush to the socket of

the Brush Compartment.

Press the Brush to the right 

and insert the left side of

the Brush into the socket.

Spin the Brush to check if it is installed correctly.

When attaching the Brush, pay attention to

the marks on each side of the Brush.

Attach the Brush

Stow the Steering Handle

Hold the lift handles with one hand,

and hold the steering handle down

with another hand

Gently lay the machine on its side so that 

the side with the dustbin is up

1

2

3

4

5

floor

Please be cautious so the handle does not

stick out of the machine.

For safety precautions, operate with 

two people.

Right side

Press the Main Power 

Switch to set it on ( l )

Check that the Robot Operations Center connection mark 

( ROC ) is displayed

If the connection mark does 

not appear, move the Machine 

to where it can be connected 

to the network.

Check that it is Connected to Robot Operations Center (ROC)

1

2

Be sure to turn off the Secondary Battery Power Button when using the Machine. When replacing

the Battery during autonomous cleaning, turn on the Secondary Battery Power Button before replacing

the Battery. Autonomous cleaning can be continued without turning the power off. After replacing

the battery, turn off the Secondary Battery Power Button.

Gently remove the film, 

being careful not to scratch

the sensors.

Cliff Sensor (x5)

Remove the Protective Film on the Sensors

Secondary Battery 

Power Button

When removing the protective

film on the sensors, check that

the Secondary Battery Power

Button    is off.

If any protective film is attached, remove the film before using the Machine.

2D/3D Camera 

(Sensor)