Figure 3: Configuration forms of WB169-430 module in
”
SOFTLINK Configurator” application
In the figure
there is a form for setting of basic module parameters a entering of commands (bordered by red
colour) and a table with results of ”RADAR” function (right). Result of ”RADAR” function using is a list of all
Sensus iPERL watermeters in the radio-reach of the module (the module received at least one message from each
of them). This list will appear in the application window after clicking to the ”RESULTS” button in the ”Basic
settings” form.
Figure 4: Form for setting of basic parameters and list of watermeters in reach acquired by RADAR function
As evident from the pictures, the application enables performing of following settings:
- setting of list of watermeters to be read
- setting of transmitting period of WMBUS messages
- setting of WMBUS frequency channel
- setting of WMBUS transmitting power
- switching to encryption mode and entering of encryption key
hspace*0,5cm- starting of one-time testing transmission
- starting of multiple (10 times) transmission series (SENDPER 10)
- switching of RADAR mode for 60 seconds (LAUNCH RADAR)
- displaying of RADAR function results (RESULTS)
- sending of RESET command to the module
As the
”
SOFTLINK Configurator” application is continuously developed and improved, the screen previews of
WB169-430 module configuration forms can vary in time.
WB169-430
16
