MANUFACTURER’S WARNING
In addition to the Safety Instructions found in the beginning of this manual,
these warnings have been assembled to help you enjoy the safe use of your
Softub spa.
Reading and understanding these warnings will allow you to reduce the risk of
causing inadvertent damage to your Softub spa, your surroundings, or yourself.
Read these warnings carefully.
1. Always disconnect your motor unit from the power supply before
draining and while filling.
2. The water level must be 2” above all jets.
The jets can spray water out of
the tub if the water level becomes too low. This can cause the motor unit to
overheat and void the warranty.
3. Use only approved chemicals.
Use of non-approved chemicals could void
the warranty.
See pages 15
& 16.
4. Maintain proper water pH (7.4-7.8).
The vinyl liner can be damaged by an
improper pH balance.
5. WARNING: USING ANY TYPE OF POOL OR SPA SHOCK PRODUCT
WILL VOID YOUR WARRANTY.
6. NEVER use an extension cord to connect the motor unit to the power
source.
An extension cord will cause a voltage drop which may cause damage
to the pump motor and controls.
7. Do not operate without a GFCI located on the power supply.
In the event
of an electrical short, this safety device shuts off the power in a fraction of a
second.
8. Install the Softub spa only on floors or areas that can withstand
repeated exposure to water (tile, brick, etc.).
Splashing, dripping, filling and
draining are routine operations which will spill water. Equipment failure may also
cause substantial water spillage. Care must be taken that the structure
underneath the Softub spa will not warp or suffer damage in the event of a
water spill. If located in a multiple floor structure, objects on the floor below
should be protected in the event of a major spill.
9. Place only on surfaces that can withstand the floor loading
requirements of your tub.
If you do not know the rating of your floor, consult
an architect or engineer before filling. See specifications on page 22.
6
