8
GSR2600
Chapter 2
Quick Start System Setup
3.
Connect the AC/DC converter or battery to the PWR port
on the GSR2600.
4.
Press the power button to turn on the receiver. The
GSR2600 will begin an initialization sequence.
5.
Before data collection:
Optionally set up a data-collection
schedule and transfer it to the GSR2600 using the Planning
software (Refer to your Planning Reference Manual).
6.
After data collection:
Use any Sokkia software to
download the data from the GSR2600 to the PC (For
example, Spectrum Survey).
2.2
Setting Up in the Field
The following explains how to typically set up your GSR2600 to
collect static or kinematic data in the field.
These steps assume that schedule and logging parameters have
already been loaded to the GSR2600, and that an optional
handheld data collector is not being used.
Note:
If a data collector was being used, then at Step 8 when
power was supplied, the GSR2600 would accept
configuration commands from the data collector.
1.
Where possible, select a location with a clear view of the
sky to the horizon so that each satellite above the horizon
can be tracked without obstruction (minimize the effect of
multipath interference).
2.
Mount or place the GSR2600 on a secure, stable structure
that will not sway or topple.
750-1-0093 Rev 1.book Page 8 Friday, June 28, 2002 4:02 PM
