5. SYSTEM CONFIGURATION
16
●
Range Pole Type
●
Height to center of prism
The height to the center of the prism differs as shown below depending on the selection of prism/pole
combination. Read the following in conjunction with the above diagrams.
Pin Pole Type
h1:
Height from the tip of the prism foot to the center of prism is 10 cm when mounting the 360°
Prism ATP1 on the adapter SB184 and stainless steel prism foot AP66.
h2:
Height from the tip of the prism foot to the center of prism is 10 cm when mounting the 360°
Sliding Prism ATP1S on the pin pole for ATP1S PP2 and the prism is at the lowest position on
the pole. Graduations on the pin pole for ATP1S PP2 are at 5cm intervals. Aligning the top of
the sliding prism with one of the graduations then sliding up or down to the next graduation
will result in a vertical movement of 5 cm. Maximum range of the sliding pole is 40 cm.
G
•Do not subject the prism to strong shock when set at the highest position on the pin
pole. Otherwise, the prism may slip downwards.
Range Pole Type
h3:
Height from the base of the one-touch attachment to the center of prism is as follows when
mounting the 360° Prism ATP1 on the Range Pole.
AP67/67A with SB179A:
87 mm
5/8 inch Setting screw pole with SB179A and SB188: 130 mm
5/8 inch Setting screw pole with SB179B:
74 mm
The pole reading shows
Protector
360° Prism
RC
-
Controller
attachment
One-touch
AP67/67A
SB179B
SB179A
Telescopic Pole 5/8 inch Setting screw
(W5/8-11) pole
SB188
h3
Telescopic Pole AP67
example
RC-PR4
RP3
ATP1
the height from the bottom
of the pole shoe to the
center of the 360° Prism
(ATP1) when using the
configuration shown at
right
.