38
| 9.0
Communication
9.3 UPS IntelliSlot Communication Cards
The intelliSlot port accepts the following optional cards:
•
SNMPWEB Card.
The intelliSlot SnmP Card provides SnmP monitoring and control of the UPS across the network.
•
IS-RELAY.
The intelliSlot relay Card provides dry contact relay outputs for custom-wired applications and delivers
support for built-in shutdown for AS/400 systems.
Follow instructions provided with the intelliSlot card to configure multiLink, the UPS, or any additional ancillary product
for the S4KC. These instructions are also available at www.multilink.com.
9.3.1 MultiLink
multiLink continually monitors the UPS and can shut down your computer or server in the event of an extended power
failure. it can also be configured for use without the USB cable when the intelliSlot SnmP/Web card is installed in the UPS.
Additionally, multiLink can be configured to coordinate shutdown across the network with other computers running
multiLink when you purchase a multiLink License Kit. For more information about the intelliSlot SnmP/Web Card and
multiLink License Kits, visit our Web site (www.solahd.com) or contact your SolaHD representative.
9.4 Remote Emergency Power Off
The UPS is equipped with a remote Emergency Power Off (rEPO) connector.
The user must supply a means of interfacing with the rEPO circuit to allow disconnecting the UPS input feeder breaker to
remove all sources of power to the UPS. All connected equipment must comply with national and local wiring codes and
regulations.
1
2
Normally closed switch system (fail-safe)
UPS ships with REPO jumper
installed allowing the UPS to operate.
Opening the REPO connection will disable the UPS.
Manual restart using the front panel is required
after the REPO connection is closed again.
1
2
Figure 27: REPO switch connection diagram
!
CAUTION
To maintain safety (SELV) barriers and electromagnetic compatibility, signal cables should be shielded and run
separately from power cables.