10
3. Determine the height position inside the rack enclosure where you want
to mount the UPS or battery cabinet.
Install rear member of each
bracket assembly into rack
enclosure with two (2) M5
screws provided in this kit.
(See figure at right.) Return
flanges on bracket assembly
fit to the inside of rack
mounting rails. Insert
screws loosely (finger-tight)
into top and bottom holes of
return flange on rear member.
Extend bracket assembly by
sliding front member
forward until it touches the front rack mounting rail. Insert two (2) M5
screws loosely (finger-tight_ into top and bottom holes of return flange
on each front member. Make sure bracket assemblies are at the same
mounting height on all four (4) rack mounting rails.
CAUTION
Re duce risk of tipping the rack enclosure by placing UPS or
battery cabinet in the lowest possible rack position.
4. Locate eight (8) M4 screws and eight (8) M4 nuts from hardware pack
in this kit. Each nut has a locking, nylon insert that begins gripping the
screw when it is halfway tight. Make sure to tighten nut and screw
completely to assure locking action. Fasten rear member and front member
together using four (4) screws and four (4) nuts per bracket assembly as
shown in the figures below. For maximum support, locate fasteners for
each bracket assembly as far apart as possible, depending on rack depth,
while still joining both members (See figures below). Check alignment of
bracket assemblies and TIGHTEN ALL SCREWS FROM
Steps 3
and
4
.
!
Front Rack
Mounting Rails
Rear Rack
Mounting
Rails
32” Rack
Depth
M4 Nuts
M4 Nuts
M4
Screws
18”
Rack
Depth
M4 Nuts
M4 Nuts
M4
Screws
Summary of Contents for S4K2U Series
Page 1: ...S S4K2U Industrial Online Series UPS POWER AVAILABILITY 700 3000VA 120V USER MANUAL...
Page 2: ......
Page 39: ......