The Answer in Power Protection
ups
320
Quick Startup
1 Connect the input cord to the back of the unit. Plug the unit
into a wall outlet.
2 Let the unit charge the battery for 8 hours. You may use the
unit while the battery charges. However, the battery backup
runtime will be reduced until the battery is fully charged.
3 Press the On/Off switch to turn the unit on. The unit will beep,
all of the front panel LEDs will light for a moment, the unit will
beep again, the yellow battery light will light and then the
green line LED will come on. The green line LED should
remain on. If not, see the Troubleshooting section on page 6.
4 Switch off the load equipment and plug it into the outlets on
the back of the SOLA 320 UPS.
5 Switch on the load equipment one piece at a time.
6 The Telephone/Network Surge Protection jacks will protect
equipment (phone, fax,
modem, or 10BASE-T
network connection) that
utilizes an RJ-11 or RJ-45
connection. Plug the single
telephone line or 10BASE-
T network connection into
the surge protection jacks
on the back of the SOLA
320 UPS. Use a phone
jumper cable and your
existing cable to connect
your equipment. Network
cabling is not provided. This connection is optional. It is not
needed to use the SOLA 320 UPS.
Summary of Contents for 0320-0400A
