Sola 600/43, Manual

26

ELECTRONICAL CONTROLLER

PLEASE NOTE: 

THE IMPULSE NUMBER AU-

TO-CALIBRATION MODE IS MORE ACCURATE 

AND A FIELD TEST PERFORMANCE IS REQUIRED.

Auto-calibrating the speed sensor

1-  

Mark 100 metres.

2-  

Select channel 1 (speed).

3-  

Press  

  and hold it while pressing 

.  

The screen will display “Auto”. Release it.

4-  

Cover the 100 marked metres. The monitor will count the 

sensor’s impulses.

5-  

After finishing, press 

 again. 

By doing this, the monitor retains the impulse number in 

the memory.

8.3  TOTAL AREA / SEED DRILL WIDTH – C2

Two independent total areas can be marked.

Displaying the total area

1-  

Select channel 2.

2-  

Press 

 to display total areas 1 and 2 on the screen.

First, “tot. 1” will be displayed and immediately afterwards 

the value in Ha will be shown.

Setting to zero the total areas

1-  

Select channel 2.

2-  

Press  

 to display.

3-  

Press and hold  

  for more than 5 seconds.

Programming the working width

1-  

Select channel 2 of the area.

2-  

Press and hold  

 for more than 5 seconds until the wi-

dth value is displayed and, without releasing it, press the 

central button to modify the flickering digit.

3-  

Press and hold the flickering digit for more than 3 se-

conds to modify its value.

4-  

Release all buttons to return to the normal state.

Working in micro mode

When working with the distributor in the micro-dosing 

mode (for small hoppers and minimal doses),

press and hold  

 button for more than 3 seconds until the arrow indica-

ting the micro mode is displayed. In this situation, the moni-

tor will keep the speed and actual real working area.

Press and hold  

 for more than 5 seconds until the indi-

cating arrow disappears to resume normal position.

8.4 

FRONT PANEL WITH TRAMLINING 

(OPTIONAL)

SEL

STOP

Ha 0

MICRO

NEUMASEM PLUS

C1  C2  C3  C4  C5  C6

Fig. 61

Screen

Total sowing shut-off 

Microdosing

Total shut-off 

controller

Area total 1 and 2 

programming

Central button

Channel selector

Value and digit selector

Shut-off sowing from folding parts

Auto-calibration 

programming

Setting to zero of Areas

Shutting-off controller 

of the folding parts

Selected channel

The monitor provided comes programmed especially for 

your model of seed drill. The user will only need to observe 

the displayed values and no extra programming is required.

The monitor shows 6 different channels or readings, as well 

as 3 different arrows showing the states.

C1

 shows forward speed in m/sec.

C2

  shows two different hectares (for example on partial 

and one total hectare). 

C3

 tramlining.

C4

 shows the fan’s rpm.

C5

  shows the turning speed of the distributor’s axle’s in 

rpm.

C6

 shows if the hopper’s seed level is too low.