Sola AURA-3215, Starting Manual

10

STARTING

4- 

STARTING

4.1 

COUPLING THE MACHINE TO THE TRACTOR

The front hopper AURA-3215 is equipped with a three-point linkage 

of cathegory 2.

To couple the hopper to the tractor, follow these steps:

1-

Fix the three-point linkage to the tractor using 3 bolts.

2-

Connect the hydraulic plugs to the turbine or if not feasible, con-

nect the hydraulic multiplier group to the front power take-off.

3-

Connect the 7 pin pineapple to the front electrical outlet of the 

tractor.

4-

Installing the controller (as applicable):

A-

 ISOBUS

: 

1- 

Install and connect the cables from the front hop-

per up to the rear ISOBUS take. Turn the tractor’s 

console on and download the program. 

B-

PERFORMER 530

: 

1- 

Install and connect the cables from the front hop-

per up to the controller in the tractor’s cabin. 

2- 

Install the switch in the rear duckfoot and connect 

to the controller. 

3- 

Connect the 12 VCC take from the controller to the 

cabin’s take. 

4- 

Connect the cable of the speed sign from the 

tractor’s cabin take or if applicable from the exter-

nal radar.

5- 

Turn the controller on.

C-

NON-APPLICABLE: 

for transfilling models.

IF THE CONTROLLER DOES NOT TURN-ON, CHECK THE 

CONNECTIONS.

5-

Link the rear duckfoot with the specific accessories for the front 

hopper AURA-3215. 

6-

Install and connect the TRANSPORT TUBES from the front hopper 

up to the specific accessories of the rear duckfoot.

7-

Lift up the front hopper and put the support feet in a working 
position.

IF YOU DON’T FOLD THE SUPPORT FEET DURING 

TRANSPORTATION OR WORK OF THE FRONT HOPPER,  

IT MAY SUFFER DAMAGES.

DURING THE TRANSPORT OF THE MACHINE CLOSE THE 

CHOPPER TO PREVENT IT FROM COMPACTING THE MA-
TERIAL IN THE METERING BOX.

TRANSPORT POSITION

WORK POSITION

PREVIOUS VERIFICATION:

1-

In working conditions (with the rear machine connected to the 

tractor and also to the front hopper and the hopper’s top closed), 

make sure that the turbine spins and the pressure indicated by the 

pressure gauge is at least 40 cm of water.

2-

Verify that the dispenser’s engine spins constantly. Perform a TEST 

(refer to the controller’s manual).

4.2 TRACTOR’S REQUIREMENTS

MACHINE 

COMPONENT

REQUIREMENTS

TRACTOR

TURBINE

Hydraulic connection with 1/2" outlet and free 
3/4" return or 540 rpm front power take-off

TRANSPORTATION 

LIGHTS AND WORK 

LIGHT BULBS

Front plug for 7 pin pineapple

Dispensers

A.

ISOBUS Connection or 12 vcc connection to 
cabin (for dispensing) 

B.

 Front 12 vcc intake

THREE-POINT

FRONT THREE-POINT LINKAGE

Frame and scheme of the 7 pin connector:

1

5

4

7

6

3

2

Pin Number

FUNCTION

Intensity (A)

1

Left intermittent

2

2

Short lights

6

3

Mass

-

4

Right intermittent

2

5

Position lights

1

6

Long lights

8

7

Work headlights

2,5