EN
•
6.When the iron is finished, place the iron in an
upright position or on the base when the iron
is interrupted
•
7.Disconnect the iron from the mains supply.
Pour of any remaining water and leave the iron
to cool off.
CONTINUOUS STEAM
•
Heating completed, temperature stabilized
•
2.Start steam switch, can choose large steam
or ECO steam at the same time, the two stalls
can be switched at any time. Fig. 5
SHOT OF STEAM
•
When the heating is completed, the tempe-
rature is stable.
•
Press the steam in two times quickly, and the
steam will start to explode in two seconds,
while the steam will flash for 3 seconds. Fig.6
SELF CLEANING
•
1.Please make sure there is enough
water in
the tank before cleaning
•
2.Please put the iron in a safe position before
cleaning to prevent people from being injured
by hot water during cleaning
•
3.After the heating is complete , the long press
the cleaning switch for 3 seconds , and the iron
enters the cleaning mode .The display on the
screen flashes and goes with the 3 sound of
bees. Fig. 7
•
4.Two minutes later, the buzzer rang three
times, indicating that the cleaning was
complete.
AUTO SHUT OFF
•
When the iron is stationary for more than 10
minutes, the iron goes out of power mode
•
The poweroff sign flashed on the display, ac
-
companied by six buzzing sounds
•
Press the steam switch to restore the power
•
Irons will not be cut off during steam discharge
•
If you need stop the process switch off the
item
ANTI DRIP
•
This iron is equipped with a drip stop function:
the iron automatically stops steaming when
the temperature is too low to prevent water
from dripping out of the soleplate.
ANHYDROUS DETECTION (NO WA
-
TER DETECTION)
•
In the course of working, if there is no water
in the water tank, the pump will automatically
stop working to protect the life of the pump
FAULTSREASONS AND SOLU-
TIONS
IRON EMITS AN ODOR OR SMOKE
•
Iron gives off an odor when turned on for the
•
first time. Oils used during manufacture need
•
to be burnt off allow ten minutes for odor to
•
disappear.
IRON DOES NOT HEAT
•
The iron should be plugged into a 230 Volt ,
•
Whether the power switch is turned on
IRON DOES NOT STEAM
•
The water tank many be empty. Turn off the
•
steam regulator and add water. Allow the iron
•
to heat, and then set the turn on to the steam
•
setting.
IRON IS LEAKING
•
The temperature setting is too low to produce
•
steam. Shot of steam used too much, allow
•
iron to re-heat.
Summary of Contents for CPB6100
