ENGLISH
EN
DESCRIPTION
A Steam hose
B Iron stand
C Mains cable
D ON button
E Hose disconnection tabs
F Boiler cleaning cap
G ECO mode indicator
H Function change button from default to ECO
mode
I Low water indicator
J Steam by default indicator
K Scale cleaning indicator (red)
L Stand activator and boiler scale cleaning
warning reset button
M On standby indicator (green)
N Water tank release button
O Removable water tank
P Max. water level indicator
Q Transportation lock
R Transportation unlock button
S Steam activation trigger
U Temperature selection control
V Iron ready indicator
W Soleplate
INSTRUCTIONS FOR USE
BEFORE USE:
•
Make sure that all products’ packaging has
been removed.
•
To eliminate the smell given off by the appli-
-
mended to have it on at full power for 2 hours
in a well-ventilated room.
FILLING WITH WATER:
•
turning on the appliance.
•
Remove the appliance’s deposit.
•
Fill the deposit taking care to observe the MAX
level (P) (Fig.1 + Fig.2).
•
Put the deposit back into its housing, ensuring
that it is inserted properly.
•
Check that the safety cap is screwed on tightly
before switching on the appliance.
USE:
•
Unroll the cable completely before plugging it in.
•
Connect the appliance to the mains.
•
Turn the appliance on, by using the on/off but-
ton.
•
The pilot light (J) comes on.
•
Turn the thermostat control to the desired tem-
perature position.
•
Do not use temperatures higher than those in-
dicated on the garments to be treated.
Polyester, Nylon…).
Temperature for silk and wool.
Temperature for cotton. (Minimum
temperature for steam ironing)
Max Temperature for linen.
•
lowest temperature. (For example, select the
temperature for polyester for an article made
out of 60% polyester and 40% cotton).
•
Wait until the steam ready light (J) comes on.
•
If the red scale cleaning light is on (K) proceed
immediately with the boiler descaling process,
see CLEANING section, and then after clean-
ing press the reset button (L) to restart the cy-
cle again.
DRY IRONING:
•
The appliance has a steam activation trigger,
which if not pressed makes it possible to iron
dry (without steam).
STEAM IRONING:
•
It is possible to iron with steam whenever the
temperature is selected.
STEAM FLOW CONTROL:
•
The appliance has a control knob (S) that al-
VERTICAL STEAMING:
•
It is possible to iron hanging curtains, items of
clothing on his hanger, etc. To do so, follow the
instructions:
•
Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction (U
•
Move the iron in a top to bottom direction while
pressing the steam control (S). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material. For oth-
keep the iron base at some centimetres of dis-
tance.
•
During extended periods of vertical ironing,
drops of water may come out of the soleplate,
put the iron back in the horizontal position, wait
