14
IRONING RECOMMENDATIONS
1 When the pilot light (11) goes out, indicating that the desired temperature has been
reached, rotate the steam selector (10) until the desired steam flow is obtained (fig. 5).
EMPTYING THE WATER TANK
!
When you finish ironing, always empty the water from the tank.
1 Set the steam selector (10) to the closed position
and the temperature selector (9)
to the
0
position.
2 Unplug the plug from the mains
3 Open the water filler opening (5) and place the iron face down over the sink, gently
shaking it to completely empty the tank.
4 Wait until the iron is completely cold and store it in the vertical position in a safe place.
IRONING RECOMMENDATIONS
STEAM IRONING
For professional ironing results, we recommend you steam iron garments first and then
dry iron them.
SUPERSTEAM
!
If you want more steam while ironing, press the button (8) two or three times, aim the
supersteam at the desired area of the garment and pass the iron soleplate over it to dry
it. Thus is useful for eliminating wrinkles.
!
The supersteam may not be released on the first occasions.
This is normal. Press the push-button a couple of times. Once the supersteam circuit
has been primed, the jet of steam will be released.
• We recommend pressing the control at 5-second intervals.
VERTICAL STEAM
!
This allows you to remove creases from delicate garments without having to put them
on the ironing board: jackets, overcoats, curtains, etc.
1 Fill the water tank as explained in the “BEFORE STARTING TO IRON” section.
2 Place the garment on a hanger, well away from other garments, people, animals, etc.
Do not discharge steam onto a garment hanging in the wardrobe or on a person.
3 Set the steam control (10) to the closed position
and the temperature selector (9)
to the
Max
position.
4 Bring the iron close to the garment, in the vertical position, (between 15 and 30 cm) and
press the supersteam button (8) once only. Do not position the iron too close to the
garment, because you could damage it.
5 Wait a few seconds before pressing the button (8) again, so as not to damage the
garment. Most wrinkles can be eliminated with three sprays of steam.
DRY IRONING
1 If there is water in the tank, turn the steam selector (10) to the closed position
(fig. 2).
2 Plug in the iron and set the temperature selector (9) to the desired position.
The pilot light (11) will go off when the temperature is reached.
IRONING WITH SPRAY
!
Spray can be obtained by pressing the corresponding button (7) when
dry ironing or
ironing with steam. The iron is at any temperature level.
• Press the spray button (7)
as many times as you want to use this function.
