CN6 (RS232 BYPASS)
This connector is used to plug in Fortin, iDatalink, and/or Expresskit bypass modules. Solace remote starters
are 2-Way datalink compatible with all manufacturers. Please see either manufacturer installation guides for
more info. The required data protocol must be selected in Menu 2-11. It is set to 2-Way iDatalink protocol at
default. An optional cable is required when using Expresskit Bypass modules.
CN7 (SHOCK SENSOR)
PIN 1 - (-) INSTANT TRIGGER INPUT
-
If this wire receives a ground signal from any sensor the alarm will go into full
trigger mode. Connect this wire to the instant trigger wire of an external alarm sensor.
PIN 2 - (-) WARN AWAY TRIGGER INPUT
-
If this wire receives a ground signal from any sensor the alarm give’s a warn
away consisting of 3 siren chirps/horn honks, notifying the individual the car is equipped with an alarm system. This also
monitors the exterior zone of a proximity sensor. Connect this wire to the pre-warn or pre-shock to an eternal alarm sensor.
PIN 3 - 12V (+) POSITIVE OUTPUT
-
This wire supplies a 12V (+) output is can be used for auxiliary alarm sensors such
as shock, tilt, audio, and proximity.
PIN 4 - (-) GROUND OUTPUT
-
This wire supplies a ground (-) output is can be used for auxiliary alarm sensors such as
shock, tilt, audio, and proximity.
CN8 (BYPASS SUPPLY)
WHITE/PURPLE - (-) 325mA GROUND WHEN RUNNING
-
This wire will send a (-) output whenever the remote start
is engaged This wire can be used in multiple scenarios, the most common is connecting to a bypass module so that it turns
on when remote starting.
RED - (+) 1 AMP POSITIVE OUTPUT
-
This wire supplies a 12V (+) output that can be used for a bypass module input,
the coil side of a relay, or optional low amperage accessories such as GPS modules, or alarm sensors. DO NOT connect to a
high amperage circuit as damage may occur.
BLACK- (-) 325mA GROUND OUTPUT
-
This wire supplies a (-) ground output that can be used for a bypass module
ground input, the coil side of a relay, or optional low amperage accessories such as GPS modules, or alarm sensors.
OPTIONAL RELAY PACK
The optional relay pack is used when High Current Output is required on older vehicles. The Relay Pack snaps
in and can only be removed by removing 2 screws on bottom of relay pack and separating the case.
See Relay Pack Installation sheet included for wire descriptions.