DISPLAY PANEL
19
STANDARD HEATING MODE
Standard Heating Mode is the normal day to day operational mode of the heat pump. The heat pump will
operate when heating of the water is required, and there is an electricity supply to the water heater, and the
heat pump is turned “On” at the Display Panel, and the water temperature in the bottom part of the water heater
is 39°C or lower.
The heat pump must be “On” at the Display Panel for the heat pump to operate and heat the
water.
Standard Heating Mode must be turned on and t
he “Standard Heating” key illuminated red for the heat pump
to operate.
If the
“Standard Heating” key is illuminated blue:
•
Press the “Standard Heating” key.
The “Standard Heating” key illuminates red.
Standard Heating Mode has been turned on.
Timer periods can be set to control the hours of operation of the heat pump. Refer to
on page 21.
A set Timer period can be manually overridden
. To override the Timer during a Timer ‘OFF’ period:
•
Press and hold t
he “On / Off” key for 2 to 3 seconds to turn the heat pump “On” at the Display Panel.
The heat pump will remain “On” at the Display Panel until the end of the next Timer period.
If the electricity supply is switched off or is interrupted to the water heat
er whilst the heat pump is “On” at the
Display Panel, when the electricity is switched on or reconnected
again, the heat pump will revert to “On” at
the Display Panel, unless the time is outside of a Timer 1 or Timer 2 set period. At the commencement of the
next Timer period the heat pump will automatically
turn “On” at the Display Panel.
During normal day to day operation of the water heater, it is not necessary to turn the heat pump “Off” at the
Display Panel. It is necessary though to turn the
heat pump “Off” at the Display Panel to complete or activate
particular user function settings. It is also necessary to then turn the heat pump back
“On” at the Display Panel
after the completion of these user function settings.
TURNING THE HEAT PUMP “ON” OR “OFF” AT THE DISPLAY PANEL
•
To turn the
heat pump “On” at the Display Panel
:
◼
Press and hold the
“On / Off” key for 2 to 3 seconds.
The ‘TEMP’ icon illuminates.
The water temperature in the upper part of the water heater illuminates in the Main Display Area.
The Useable Water Quantity icon bars illuminate (if the water is hot).
The Display icons of the current set functions illuminate blue.
The Selection Key icons displaying the current operation and in use illuminate red.
The Selection Key icons which are not currently in use illuminate blue.
•
To turn the
heat pump “Off” at the Display Pa
nel:
◼
Press and hold the
“On / Off” key for 2 to 3 seconds.
The ‘TEMP’ icon, water temperature display and Useable Water Quantity icon bars go out.
‘OFF’ illuminates in the Main Display Area.
The Display icons of the current set functions illuminate blue.
The Selection Key icons displaying the current operation and in use illuminate red.
The Selection Key icons which are not currently in use illuminate blue.
If the heat pump was operating, the fan may continue to run for up to one (1) minute.
