Solar Arc Smartpool S204, Installation And Instruction Manual

4

version 1.1

(732) 730-9880

Where Should I put the SolarArc?

• Choose a hard, level surface. 

• The unit(s) should never be placed on a roof, or any structure.

• Install SolarArc on the ground in a location where it will receive at least 6 hours of direct sunlight a day.

• The unit(s) should be angled toward the sun using the legs provided. 

NOTE:

The SolarArc is to be installed between the filter and the pool water inlet. SolarArc must be placed after the 

filter to prevent buildup of dirt/debris in the tubing.

NOTE:

If SolarArc needs to be further from the filter than the hoses allow, you may need to purchase a longer hose

with the 1½” diameter openings, or connect 2 hoses together using  a 1½”-1½” coupler  (not included). In this case
make certain you have two hose clamps to secure the hoses to the coupler. If the hoses are too wide to fit the hose
connector, put the 1¼”-1½” tube reducer on the hose connector and continue.

CAUTION

Ensure ALL hose connections are tight and the hoses are NOT kinked or bent at severe angles. If the hoses are leaking,
check to make sure ALL of the parts that have O-Rings have them attached and are screwed on tightly. DO NOT over
tighten hose clamps.

NOTE:

The short rubber hose (see parts photo on page 11 under letter “D”) is only used to connect multiple solar

heaters together.

What Tools Will I need?

• All you need is a flat Head Screwdriver or 5/16th” nut driver.

When should I run the SolarArc?

The SolarArc works best when the sun is shining.

Installation

1.

Remove SolarArc from box.

REAR

FRONT

From
Filter

To
Pool