Professional, Vision
5
1408TU0710
J
Warning:
Danger due to high voltage!
Even in disconnected condition the inverter can
retain high voltages, which is a major shock
hazard. Therefore:
X
Be very cautious when working with the
inverter and wires!
X
After switching off the inverter as well as
before working on the inverter, make sure to
regulate the time intervals as recommended
by the manufacturer so that the high voltage
components can be discharged!
Make sure to adhere to the assembly regulations
of the inverter manufacturer!
J
Warning:
Danger due to electric arc!
The solar modules generate a direct current when
exposed to light. When opening a closed circuit,
e.g. disconnecting the direct current wire from the
loaded inverter, a fatal electric arc may occur.
X
Never disconnect the solar generator from the
inverter while the inverter is connected to the
grid!
X
Make sure to use only flawless wire
connections! Connect wires seamlessly and
keep them free from dirt!
J
Electrical installation
The solar modules are designed for use in PV
systems of application class A and are approved
for operation in systems with dangerous direct
current (more than 120 V DC in accordance
with EN 61730) and power. PV modules of this
application class are approved for operation in
installations with unrestricted access. Professional
and Vision modules from Solar-Fabrik AG, which
are qualified under EN 61730 and have been
properly installed, meet the requirements of
protection class II.
Safety information
J
Transport, temporary storage
and safe unpacking
The modules are sensitive technical components,
which must be handled with utmost care.
Therefore, be particularly careful during transport
and temporary storage and leave the modules in
the package until they are used. Always lift and
carry the module with both hands and never carry
by means of the junction box.
Do not drop the modules or place them down
clumsily on a hard floor and/or on the module
corners. Do not place any objects on the modules.
Do not stack the modules without protection.
Avoid deflection of the modules. Do not walk on
the modules. Do not treat with sharp objects and
keep all electrical contact areas clean and dry.
For docum
entation purposes, the serial number should
be noted. If required, the modules should be
temporarily stored in a dry, ventilated room.
Clean, non-slip gloves must be worn during all
transport and installation work to prevent cut
injuries from the panel edges. Contamination
of the solar glass with fingerprints must also be
avoided, as this may damage the special coating
on the glass.
Please pay special attention to the warnings on
the package as well as on the enclosed unpacking
instructions!
