8
3. General Safety Advices
Please ensure all necessary measures are taken to prevent accidents. The use of SolarSets in applications that may endanger human
lives is prohibited, including in air and road transport systems. SolarSets must not be used for anything other than their expressed
purpose. Solar Frontier strongly advises you to follow the instructions below in order to avoid bodily injury, damage to property and/or
death.
SolarSets sold by Solar Frontier Europe GmbH may only be installed by authorized professionals. Solar Frontier will not
assume any liability for personal injuries and damage to property arising from improper use, wrong assembly, operation
and maintenance of SolarSets. As soon as it becomes evident that safe operation is no longer possible (e.g. visible damage),
remove the SolarSet immediately from the grid.
2. Identification
Type plate of the Solar Frontier
inverter SF-WR-3000
1
Barcode for internal purposes
2
Technical Data – DC-input
3
Article number and product designation
4
Manufacturer
5
Protection Class II and CE symbols
6
Country of manufacture
7
Technical data – AC-output
8
Protection classification and grid-monitoring standard
9
Serial number (and barcoded serial number)
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
3.1 Safety advice for photovoltaic modules of type Solar Frontier SF165-S
Type plate of the Solar Frontier
module SF165-S
1
Certifications and protection classes
2
Serial number (and barcoded serial number)
3
Name of product
4
Technical data at STC
5
Manufacturer and country of manufacture
6
General product characteristics
7
Serial number on frame
• Installation, wiring, and maintenance of SF modules must only
be carried out by licensed and trained persons.
• Ensure that all instructions and information related to SF
modules and other balance of system components are fully
understood prior to handling and installing a PV solar system.
• The front surface of SF modules shall be covered with an
opaque material during installation to decrease the potential
of electrical shock.
• SF modules only generate direct current (DC) electricity.
• SF modules do not have the ability to store electricity.
• SF modules will experience higher voltage when connected
in series and higher electrical current when connected in
parallel.
• Only interconnect SF modules with similar electrical charac-
teristic in series or in parallel to prevent system imbalance
conditions and module damage.
• The PV array open-circuit voltage must never exceed the
maximum system voltage (including in low temperature
conditions).
• Leakage currents could create a shock hazard or fire.
• Do not disconnect operational modules or electrical arcing
may occur. This may result in serious bodily harm or death.
• Do not use SF modules for purposes other than terrestrial
power generation to prevent electrical shock, fire or other
accidents.
• Do not artificially concentrate sunlight on modules using
