147
GoodWe
Connect the inverters to each other.
•
Wiring via 3-pin cable with terminal strip plug.
•
Where to connect: RS485 socket in the inverter.
Procedure:
1. Plug terminal strip plug into RS485 socket of inverter 1.
2. Continue wiring via RS485 socket to inverter 2 (according to manufacturer‘s instructions).
3. Plug the other terminal strip plug into the RS485 socket of inverter 2.
4. Connect the other inverters to each other in the same way.
5. Insert the terminal block connector into the Solar-Log™ RS485 socket.
6. Terminate the last inverter according to the inverter instructions.
Summary of Contents for Solar-Log
