44
Advanced Energy
Connect the inverters to each other
The wiring is done using a
•
self-made connection cable and terminal block connector.
•
Where to connect: Terminal strip inside the inverter.
Procedure
1. Open the inverter as shown in the inverter‘s instructions.
2. Pull the free wires through the wire opening in the inverter.
3. Connect terminals GND, D+ and D- of inverter 1 to the corresponding terminals on inverter 2.
4. Connect the other inverters to each other in the same way.
5. Terminate the last inverter according to the inverter instructions.
Inside the inverter set the supplied jumper from „J4“ to „J5“.
6. Address the individual inverters in accordance with the manufacturer‘s handbook: Inverter 1 should be the
inverter that is directly connected to the Solar-Log™. To this end, set SW1 to „0“. Depending on the position of
the inverter in the bus, SW2 should be set to 1-9.
If more than 9 inverters are to be connected to one Solar-Log™, please read the manufacturer‘s instructions
for further information.
7. Close the inverter if no other inverters are to be connected.
8. Insert the terminal block connector into the Solar-Log™ RS485 socket.
Summary of Contents for Solar-Log
