446
Kyocera Inverter/Battery System
Procedure
1. Unscrew the side cover as shown in the inverter‘s instructions.
2. Connect the self-made RS-485 cable to the terminal block on inverter 1.
3. Connect other end of the self-made RS-485 cable to the terminal block on inverter 2 or to the battery system.
4. Connect the other inverters to each other in the same way.
5. Screw the inverter cover on again.
Allocate communication address:
•
Procedure: According to the manufacturer‘s manual.
If all of the devices have been wired, they have to be powered for detection.
Note
Only one battery system can be connected to a Solar-Log™ device.
Summary of Contents for Solar-Log
