493
Rainwise - PVMet™-200 (Weather station)
3
Rainwise - PVMet™-200 (Weather station)
3.1
PVMet™-200 (Weather station)
Termination
Addressing
Interface
-*
No
RS485
Selections available under Sensor/Rainwise/PVMet200.
Supported by firmware 4.1.0 and higher.
Overview
•
Integrated interface.
•
Where to connect: Terminal strip on circuit board under the cover.
•
Communication address does not have to be assigned.
•
4-pin wiring.
•
Installation steps:
•
Switch of the PVMet™-200 and the Solar-Log™.
•
Connect the PVMet™-200 to the Solar-Log™.
Connect the PVMet™-200 to the Solar-Log™.
The wiring is done using a
•
self-made, shielded 4-wire data cable with a terminal block connector.
Procedure
1. If you are making the cable yourself, connect the wires as shown in the following diagram:
Solar-Log™ terminal strip connector
Terminal strip on circuit board
Terminal
PIN
►
1
►
RS485 A-
►
3
►
Ground/GND
►
4
►
RS485 B+
*Termination
:
Please contact Rainwise for information on termination.
Note
Only one PVMet™ -200 can be connected and visualized per Solar-Log™ device.
Summary of Contents for Solar-Log
