Typ 3.64 Installation Manual
13
Typ 3.64
Motor Limit switches. Hz02
IMPORTANT
• Only power up one motor at a time.
• Have the transmitter within 3m of the motor during setting process.
• Motors acknowledge by running briefly in both directions (double shuffle).
• Motors only run in deadman (impulse) mode until a transmitter is added to the memory.
Setting Motor Limits
1. Connect the mains supply to the motor. This should be via an isolator switch in case the programming has to be
wiped.
2. Press the up and down button at the same time to initiate programming; the motor will operate in then out for
half a second (a double shuffle). The motor operation will be impulse only at this stage.
Checking Motor Direction
1. Press the up button on the transmitter. The blind should retract. If the motor direction is incorrect then press the
middle stop button for approximately
3 seconds
. The motor will do a double shuffle and the direction will have
been reversed.
Setting the End Limits
1. Press & hold the down button and the motor will deploy. Continue this until the required deployed position is
reached, use the up/down buttons to achieve the correct position. To memorise the fully deployed position press
the stop and up button simultaneously. The motor will then run automatically in the retract direction.
2. When the motor arrives at the desired retract position press the stop button. Should it be necessary to adjust the
final position use the up/down buttons?
3. To memorise the limit position press the stop and down buttons simultaneously. The motor will now run in the
deploy direction. To validate the settings press and hold the stop button for
2 seconds
. The motor will stop and
then do the double shuffle.
Confirming the Master Transmitter
1. To operate the motor in stable mode press the programming button for approximately
1 second
; the motor will
again do the double shuffle. This is now the master transmitter and can be used to programme additional
transmitters.
Programming additional Transmitters
1. To programme additional transmitters do the following: press the master transmitter programming key for
approximately
3 seconds
, the motor will do the double shuffle. Take the new transmitter and select the required
channel. Press the programming key for 1 second, the motor will again do the double shuffle and is now
programmed.
